IMS ROBOTICS MICRO S - Page 86

MICRO S automatic Cutter motor
Number:
RH-11.014 A
Scope:
IMS Robotics
Document Management
Date:
08 July 2022
Author:
00145
Checked:
Page:
86 of 113
1. Carefully clean the PCB using spirit
before mounting the camera.
2. Apply Energrease MP-MG 2 to the O-ring
and insert it into the groove provided on
the camera housing.
3. Mount the camera and screw the test kit
adapter on.
4. Fill the cutter motor with nitrogen and
check for leakage.
5. Check the light and camera function.
Caution
Spirit should not get into the camera.