C-COM Satellite Systems Inc. Page 39 of 164
1 – RF Search Mode Status
N RF Mode is disabled; Y will be displayed when enabled.
N RF override mode is disabled; O will be displayed when enabled.
RF Threshold (55) Value will be displayed here, this value is configurable.
RF/DVB signal value (30N) – If in RF search mode this will represent RF signal value, if in DVB
Mode it will display DVB carrier signal. The letter ‘N’ next to the
RF Value indicates the LNB is not being powered properly.
The letter “L” next to the value indicates a DVB signal LOCK.
2 – CP (Compass) Status
V Valid – The compass reading is functioning properly
O Override – the compass has been overridden, and direction entered manually
considered
FS Full Search – searches a full 360º search window.
3 – Compass Heading/ Calibrate/Check Compass Routine
Displays Compass Heading after Compass has been read.
Approximate Headings: North 354
East 87
South 176
West 265
Antenna will rotate 90° to each of the following positions and read the compass
at each: 0°, 90°, 180°, -90°, 0° and display the compass headings. Vehicle front
end (windshield window) must be pointed North during these routines to achieve
proper compass headings and a software pop-up will be displayed on the pc
screen to ensure this Platform is properly orientated.
4 - AZ Search Window Status
The Search Window is the area of the sky which the iNetVu
®
Mobile System will
search for the desired Satellite. It uses a rectangular window and searches for
the Satellite using smaller concentric windows until the desired Satellite is found.
To Next Page
Loading...
Need help?
General
