Inficon 3000 Micro GC - Replace the Battery

8 - 40
PN 074-519-P1C
3000 Micro GC Operating Manual
8.5.2.3 Replace the Battery
To replace the battery:
1 Shutdown the 3000 Micro GC, refer to section 6.3.3, Shutdown, on page 6-8.
2 Turn off the carrier gas.
3 Turn off the power.
4 Disconnect the power cord.
5 Remove the screws from the Portable 3000 Micro GC top cover.
6 Remove the top cover.
7 Turn Portable 3000 Micro GC over and remove the screws from the bottom
cover.
8 Remove the bottom cover.
9 Facing the front panel of Portable 3000 Micro GC, the battery compartment is
located on the top left side. See Figure 8-40. The panel covering the
compartment is held by two Torx screws on the outer edge of the panel.
Remove these screws and remove the panel.
Figure 8-40 Portable 3000 Micro GC battery compartment
Battery compartment
cover
Battery