Inficon 3000 Micro GC - Installing Inlet Filters and Genie Filter Assembly

5 - 3
PN 074-519-P1C
3000 Micro GC Operating Manual
5.1.2 Installing the 10 Micron Sample Inlet Filter
For instruction on installing the 10 micron sample inlet filter (PN G2801-60900),
refer to section 4.2.5.3, Sample Inlet Filter Assembly Installation, on page 4-13.
5.1.3 Installing the Genie Filter Assembly
The Genie Filter Assembly Kit (PN G2817A) provides gas-liquid separation
function through a Genie Membrane Separator. It is not compatible with other
sample conditioners mounted on the 3000 Micro GC front panel. See Table 5-2
and Figure 5-1 for G2817A kit contents.
Figure 5-1 G2817A kit contents
5.1.3.1 Tools Required
 5/16 in. open-ended wrench
 7/16 in. open-ended wrench
 1/4 in. open-ended wrench
Table 5-2 Genie filter assembly kit contents
Description Quantity
Outlet tube 1 ea
Genie filter assembly 1 ea
1/4 in. male nut and ferrule set 1 ea
Replacement membrane filters (5/pk) 1 ea
5/16 in. female nut and ferrule set 1 ea
Gas sampling tubing, 1/16 in. 1 ea
Replacement membrane filters
Outlet tube
Gas sampling tube, 1/16 in.