Inficon 3000 Micro GC - Initial Instrument Configuration and IP Setup

4 - 15
PN 074-519-P1C
3000 Micro GC Operating Manual
4.3 Instrument Configuration Setup
3000 Micro GC can be connected directly to the computer on a LAN using a
crossover cable (PN 5183-4649, supplied in the Shipping Kit). Use a crossover
cable to establish the initial connection.
4.3.1 Turn on 3000 Micro GC
To turn on 3000 Micro GC, set the switch on the front of the instrument to the on
position. The switch will illuminate green to indicate that 3000 Micro GC is on.
Figure 4-10 INFICON 3000 Micro GC (2-channel, two inlet instrument shown)
Channel B inlet
Channel A inlet
On/off switch