InfoPrint 6500 - IGP Emulation Menu

170
Chapter 4 Emulation Configuration Menu
IGP Emulation Menu
Define CR Code (Carriage Return)
This parameter forces the printer to insert an automatic Line Feed code into
the data stream whenever a Carriage Return code occurs. This is to be used
only if the host computer does not send Line Feeds to the printer.
• CR = CR (the default). Does NOT perform a line feed. The next print
position will be print position 1 of the current line.
• CR = CR + LF. Performs an automatic line feed. The next print position
will be print position 1 of the next line.
Emulation
Configuration
(from page 152)
Define CR
Code
Define LF
Code
LF = LF*
LF = CR + LF
Auto LF
Disable*
Enable
IGP
SFCC
7E*
1 - FF
CR Edit
Disable*
Enable
PI Slew Range
16*
15
Select
Font
0*
0 - 34
Slash 0
Disable*
Enable
Lines
Per Inch
6 Lines Per Inch*
8 Lines Per Inch
9 Lines Per Inch
10 Lines Per Inch
Skip Command
Prefix
Enable*
Disable
Power
On IGP
Enable*
Disable
Ext Execute
Copy
Disable*
Enable
IGP
Emulation
CR = CR*
CR = CR + LF
UPC
Descenders
Enable*
Disable
IGP100
Compatibilty
None*
MVP
L150
P3000
P6000
P9000
Expanded
Font
Block*
Alt Block 1
Scalable
Optimized
Ratio
Disable*
Enable
Compressed
CPI
Disable*
Enable
Ignore
Character
Ignore Mode
Disable*
Enable
Select Character
0*
0 - 255
Mono/Dual
Case
Dual Case*
Mono Case
Select Set
Disable*
UTF8
* = Factory Default