InfoPrint 6500 - Coax Interface Menu

85
Coax Interface Menu
Lead-In Characters
Set 1 <%>*
Set 2 ¬¬$
Set 3 _%_
User Defined
User Defined Codes
Start Code 1
Start Code 2
Stop Code
Alternate Set 80-9F
Printable*
Control Code
Coax Interface
(from page 58)
Print
Language
See the following
page.
Print Character
Table
2
Active Print
Language
Standard Print Language*
Alt Print Language
PA1
1
Disable*
Enable
PA2
1
Disable*
Enable
Buffer
Reprint
1
Disable*
Enable
Early Print
Complete
Disable*
Enable
Hex
Transparent
Control
Dual Case*
Mono Case
Mono/Dual
Case
Print Text
Direction
Control By Host*
Left to Right
Right to Left
Intervention
Required
Not Send to Host*
Send to Host
Compatibility
Options
See page 94
Translate
Table
Default*
Downloaded
NOTE:
* = Factory Default
1
In Coax mode, the options for PA1, PA2, and Buffer Reprint are
displayed only when the coax line is active.
2
Does not apply to IPDS.
3
The Twinax and Coax interface menus only appear in the
menus if the Coax/Twinax is installed.
4
Only if Autoswitching is enabled.
5
Only if Coax Emulation is enabled.
Cancel
Buffers
Enable*
Disable
Format
Control
Disable*
Enable
Maximum
Printable Width
13.2 inches*
13.6 inches
Hex Print
Mode
2
Disable*
Enable
Override
Host
Disable*
Enable
60*
40 - FE (HEX)
Undefined
Char Sub
SCS Buffer
Control
Don’t Wait*
Wait Until Done
C/T
Hotport
4
Port Type
Twinax*
Coax
Disable
Timeout
15 Sec*
10 Sec - 180 Sec
Report Status
Disable*
Enable
To cycle through the menus and its
options, press MENU then:
To enter a menu or select menu options,
press ENTER.
To return to a previous menu level,
press RETURN.
To exit the configuration menus
and return to READY, press START.
↑
Scroll/
Micro
↓
Scroll/
Micro
OR
Coax Interface Menu