Twinax
Interface
(4)
(from page 58)
Print
Language
See the following
page.
Print Character
Table
3
Active Print
Language
Standard Print Language*
Alt Print Language
Twinax Printer
Emulation
4234-12*
1
5225
4234-2
Cancel
Buffers
Enable*
Disable
Printer
Address
Address 1*
Address 2
Address 3
Address 4
Address 5
Address 6
Address 0
Early Print
Complete
2
Disable*
Enable
Lead-In Characters
Set 1 <%>*
Set 2 ¬¬$
Set 3 _%_
User Defined
User Defined Codes
Start Code 1
Start Code 2
Stop Code
Alternate Set 80-9F
Printable*
Control Code
Hex
Transparent
Control
Enable*
Disable
Undefined
Char Report
60*
40 - FE (HEX)
Undefined
Char Sub
Enable*
Disable
Load Alt
Char Option
Print Text
Direction
Control By Host*
Left to Right
Right to Left
Override
Host
Disable*
Enable
Format
Control
Disable*
Enable
Maximum
Printable Width
13.2 inches*
13.6 inches
Hex Print
Mode
3
Disable*
Enable
NOTE:
* = Factory Default
1
If the IPDS feature is installed, the 4234-12 option is the
default, and will appear in this menu. If IPDS is not installed, the
4234-12 option will not appear in this menu, and 4234-2
becomes the default.
2
If the IPDS feature is installed, the EARLY PRINT
COMPLETE option appears in this menu.
3
Does not apply to IPDS.
4
The Twinax and Coax interface menus only appear in the
menus if the Coax/Twinax is installed.
5
Only if Autoswitching is enabled.
LAC
Approximation
On*
Off
World
Trade
Standard Character Set*
Extended Character Set
C/T
Hotport
5
Port Type
Twinax*
Coax
Disable
Timeout
15 Sec*
10 Sec - 180 Sec
Report Status
Disable*
Enable
To cycle through the menus and its
options, press MENU then:
To enter a menu or select menu options,
press ENTER.
To return to a previous menu level,
press RETURN.
To exit the configuration menus
and return to READY, press START.
↑
Scroll/
Micro
↓
Scroll/
Micro
OR
To Next Page
Loading...