25
2
Installation
Installation, Attachment, and Configuration Overview
The following is an overview of the steps you need to complete to successfully
install, attach, and configure your printer:
1. Unpack the printer from the shipping package. Follow the instructions
provided on the shipping package.
2. Set up the printer, which includes; removing shipping materials,
connecting interface cables, loading ribbon, and loading paper. Follow the
instructions in the InfoPrint 6500 Line Matrix Printers: Cartridge Ribbon
Printers Quick Start Guide.
3. Perform an initial print test by printing the current configuration page as
described on
page 44.
4. Review the information contained in the README.1ST file on the
Configuration Utility section on the User’s CD.
NOTE: The Configuration Utility section contains a README.1ST file that
describes the contents of the CD, AIX print drivers, and configuration
information for replacing existing InfoPrint printers. In addition, there
might be another file, called README.TXT that contains information
that was added after the printer documentation was printed.
<4> Do not connect or disconnect any communication port, teleport,
attachment connector, or power cord during an electrical storm.
<5> Power off the printer and disconnect the power cord before
connecting or disconnecting communication port, teleport, or
attachment cable connector.
Before using this information and the product it supports, read the
information in “Notices” on page 321.
Note!
To Next Page
Loading...