84
Chapter 4
Twinax Interface Menu
Timeout
This is the value used by the printer to time out from the current port and
check the other ports for data to print. When the printer has not received data
from the host after the specified period of time, it needs to Timeout to service
the other ports. The available selections are:
•
15 Seconds (the default)
•
10 to 180 Seconds.
Report Status
•
Disable (the default). A fault on the printer is reported only if it occurs on
the active port.
•
Enable. The faults are reported even if the fault is not on the current
active port.
To Next Page
Loading...