InfoPrint 6500 - Page 273

Fault Correction Procedure
273
E18 DSTORE MISS
See User Manual
Yes An illegal or
unsupported
instruction was
attempted in the
application program.
1. Cycle Power. Run the
print job again. If the
message appears,
load the latest
emulation software.
2. Cycle power. Run the
print job again. If the
message appears,
record the display
message and send it to
your next higher
support facility.
E19 BREAKPOINT
See User Manual
Yes An illegal or
unsupported
instruction was
attempted in the
application program.
1. Cycle Power. Run the
print job again. If the
message appears,
load the latest
emulation software.
2. Cycle power. Run the
print job again. If the
message appears,
record the display
message and send it to
your next higher
support facility.
E20 SYS MANAGE
See User Manual
Yes An illegal or
unsupported
instruction was
attempted in the
application program.
1. Cycle Power. Run the
print job again. If the
message appears,
load the latest
emulation software.
2. Cycle power. Run the
print job again. If the
message appears,
record the display
message and send it to
your next higher
support facility.
Table 9: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution
Fault Messages