InfoPrint 6500 - Page 276

276
Chapter 7 Fault Messages
E31F EVENT 5 BP
See User Manual
Yes An illegal or
unsupported
instruction was
attempted in the
application program.
1. Cycle Power. Run the
print job again. If the
message appears,
load the latest
emulation software.
2. Cycle power. Run the
print job again. If the
message appears,
record the display
message and send it to
your next higher
support facility.
E31G EVENT 6 BP
See User Manual
Yes An illegal or
unsupported
instruction was
attempted in the
application program.
1. Cycle Power. Run the
print job again. If the
message appears,
load the latest
emulation software.
2. Cycle power. Run the
print job again. If the
message appears,
record the display
message and send it to
your next higher
support facility.
E31H EVENT 7 BP
See User Manual
Yes An illegal or
unsupported
instruction was
attempted in the
application program.
1. Cycle Power. Run the
print job again. If the
message appears,
load the latest
emulation software.
2. Cycle power. Run the
print job again. If the
message appears,
record the display
message and send it to
your next higher
support facility.
Table 9: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution