InfoPrint 6500 - Page 282

282
Chapter 7 Fault Messages
H01: PCI J12
See User Manual
No The controller board
is not communicating
with the PCI card in
PCI slot J12. This
could indicate a bad
PCI card, poor
connection, or
problem in the PCI
bus.
Contact your InfoPrint
service representative.
H02: PCI J13
See User Manual
No The controller board
is not communicating
with the PCI card in
PCI slot J13. This
could indicate a bad
PCI card, poor
connection, or
problem in the PCI
bus.
Contact your InfoPrint
service representative.
H/B CONTROL MODE
SEE USERS MANUAL
N/A A status message
indicating that one or
more hammer coils
are hotter than normal
and the printer will run
in half–speed mode
until they cool down.
This can occur during
especially dense print
jobs.
None required. The printer
automatically corrects the
condition by running at
half–speed mode until the
hammers cool down, at
which point it resumes full
speed printing.
HMR BANK NOT INSTALLED
SEE USERS MANUAL
No Hammer bank is not
installed.
Contact your InfoPrint
service representative.
HAMMER COIL BAD
#, #, #, #,...etc.
No Hammer coil(s)
number #, #, etc.
failed the current test
at power-up.
(You can continue to print
with degraded print
quality.) Contact your
InfoPrint service
representative.
ILL INST ACCSS* Yes Illegal Instruction
Access:a firmware
error on teh controller
board.
Cycle power. Run the print
job again. If the message
appears, download the
emulation software again.
If the message appears,
contact your InfoPrint
service representative.
Table 9: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution