InfoPrint 6500 - Page 49

Entering Program Mode
49
If you do not save your configuration before you power off the printer, all of the
new parameter values that have not been saved to NVRAM will be erased.
When you power the printer on again, the power-on configuration will load. If
no configuration has been designated as the power-on configuration, the
factory configuration will load.
NOTE: To avoid overwriting an existing custom set, the Protect Custom Sets
parameter must be set to ENABLE. See
page 74 for details.
Step Key LCD Results Notes
1. Press NOT READY Places the printer in NOT
READY mode.
2. OPERATOR MENU
UNLOCKED
Unlocks the Operator Menu,
which allows you to make
configuration changes.
3. OPERATOR MENU
PRINTER CONTROL
Displays the first Configuration
Main Menu option, PRINTER
CONTROL.
4. OPERATOR MENU
CONFIGURATION
MANAGEMENT
Moves to the Configuration
Management menu option.
5. CONFIGURATION
MANAGEMENT
RECALL CUSTOM SET
Selects the CONFIGURATION
MANAGEMENT menu. The
RECALL CUSTOM SET option
appears.
6. CONFIGURATION
MANAGEMENT
SAVE CURRENT
VALUES
Moves to the SAVE CURRENT
VALUES option.
7. SAVE CURRENT
VALUES
1*
Selects the SAVE CURRENT
VALUES menu.
STOP
RETURN ENTER
+
MENU

SCROLL/
MICRO
UNTIL
ENTER

SCROLL/
MICRO
UNTIL
ENTER
Saving Your Configuration in a Custom Set