70
Chapter 4
Printer Control Menu
Power Stacker
This parameter determines whether or not the power paper stacker is enabled
or disabled. This parameter is not presented if the power paper stacker is not
installed.
•
Enable (the default)
•
Disable
Auto Elevator
This parameter exists only on printers with the power paper stacker installed.
The power stacker has a sensor which detects paper movement and raises
the stacker as the printed paper stack grows. If the printer has been printing
for three minutes continually and the sensor has not detected any growth in
the paper stack, the stacker raises itself 1/4 inch automatically.
•
Enable (default). The automatic elevator on the power stacker operates
normally.
•
Disable. The stacker does not raise automatically every three minutes
and is entirely dependent on the sensor. Disable is used with extremely
high-quality print jobs that take a long time to print.
Printer Management Port
Printer Management Port is the port used to connect the printer to the
InfoPrint Printer Management Unit (PMU). This menu option is a printer
management tool that runs on Host Computers. The options include:
•
Disable (default)
•
Serial
•
Debug Ethernet
•
Debug Adapter
Top Exit Tear Distance
The eject distance for the EJECT/RESTORE type TOP EXIT TEAR.
•
7.46 Inches (default)
•
4.50 - 10.50 Inches
To Next Page
Loading...