78
Chapter 4
Twinax Interface Menu
Print Language
PRINT LANGUAGE specifies the set of print languages used by the printer.
Refer to the previous page for print language menus.
•
Standard Print Language (the default)
•
Alternate Print Language. Provides code pages compatible with 6408/
6412 Model CT0 printers. Use this option with the 5225 printer emulation.
Specifying a print quality of OCR A or OCR B will change the print language to
OCR A or OCR B.
When OCR A or OCR B is selected as the default print language, OCR A and
OCR B are the only available values for this print quality. If a different print
quality value is desired, the print language must be changed first.
Print Character Table
PRINT CHARACTER TABLE prints out a table of the twinax interface current
character set.
Character sets are shown in the InfoPrint 6500 Line Matrix Printers: CTA
Programmer's Reference Manual.
Active Print Language
ACTIVE PRINT LANGUAGE specifies which print language set will be the
active set.
•
Standard Print Language (the default)
•
Alt Print Language
Twinax Printer Emulation
This parameter defines the printer emulation, as follows:
•
4234-12 (the default)
•
5225
•
4234-2
The 4234-12 selection is only present if the IPDS feature is installed. The
4234-12 selection is the default if the IPDS feature is installed, otherwise, the
4234-2 is the default.
After the emulation has been changed, a POR status is sent to the host.
Printer Address
PRINTER ADDRESS allows you to set the device address from 0 through 6.
The host directs data and commands on the twinax line to a specific device
based on its unique device address.
After the address has been changed, a POR status is sent to the host.
To Next Page
Loading...