Inovance MD500 Series - Removing and Installing the Fan of a Sheet Metal Housing

10. Maintenance and Inspection
- 290 -
10
■
Removing and Installing the Fan of a Sheet Metal Housing (MD500T45GB-INT to
MD500T160G-INT)
Removal
1. Disconnect the fan cable
from the drive
Fan power
socket
2. Remove the four screws
from the drive.
3. Remove the fan and fan cover
from the drive.
Fan power cable
Fan cover
Fan
Installing
1. Align the mounting holes of the cooling fan, fan cover and the drive.
2. Install the fan and fan cover on the AC drive.
3. Fix the screws and ensure correct air ow direction.
Keep the air flow direction upward.
■
Replacement of Electrolytic Capacitor
If replacement of electrolytic capacitor is required, contact the agent or Inovance to perform
complete drive replacement.