Integra DRX-8.4 - Page 142

142
SetupSetup
2. Speaker
 8. EQ for Standing Wave
This controls the a󰀨ect of the standing waves that occur when sound waves
reverberating o󰀨 obstacles such as walls interfere with the original sound waves.
 Filter 1 (Default Value: 0.0dB)
Filter 2 (Default Value: 0.0dB)
Filter 3 (Default Value: 0.0dB)
1. After selecting the Filter to adjust from "Filter 1" to "Filter 3" with / , press
Enter.
2. Select the frequency with / , then adjust the attenuation with / . The
frequency can be selected between "63 Hz" and "250 Hz".
Attenuation can be selected between "0.0 dB" and "12.0 dB" (0.5 dB
intervals).
 9. Speaker Virtualizer
The Speaker Virtualizer function can be switched between On and O󰀨.
 Speaker Virtualizer (Default Value: On)
On Listening modes such as T-D that have virtual speaker e󰀨ects
can be selected.
O󰀨 Listening modes such as T-D that have virtual speaker e󰀨ects
cannot be selected.
 10. Speaker Combo
"Speaker Combo" is a function that optimizes the crossover value suitable for
Klipsch speakers.
Setting the Klipsch speaker model to be used with "Speaker Combo" updates
the content of "Speaker" - "Crossover" on the Setup menu, and the crossover is
set to the optimized value suitable for the speakers.
 Brand (Default Value: Other)
Select the brand of your speakers.
Klipsch When Klipsch speakers are used
Normal When other than Klipsch speakers are used
Front (Default Value: Other)
Center (Default Value: Other)
Height 1 (Default Value: Other)
Height 2 (Default Value: Other)
Surround (Default Value: Other)
Surround Back (Default Value: Other)
Subwoofer (Default Value: Other)
Select the series of your speakers.
Select "Other" if yours is not in the list.
"Series": Select the series of speaker.
"Model": Select the model of speaker.