129
SetupSetup
1. Input/Output Assign1. Input/Output Assign
1. TV Out / OSD
Make settings for TV output and On-Screen Displays (OSD) that appear on the
TV.
HDMI Out (Default Value: MAIN)
Select the HDMI jack to be connected with the TV.
• If devices with dierent resolutions are connected to HDMI OUT MAIN jack
and SUB jack, images are output with the lower resolution.
MAIN When connecting the TV to the HDMI OUT MAIN jack
SUB When connecting the TV to the HDMI OUT SUB jack
MAIN+SUB When connecting to both the MAIN and SUB jacks
Dolby Vision (Default Value: MAIN)
To output Dolby Vision video from the player to a TV that supports Dolby Vision,
select either the HDMI OUT MAIN jack or HDMI OUT SUB jack to which the
Dolby Vision-supported TV is connected. This setting is only necessary if you
have set "HDMI Out" to "MAIN+SUB" and you have connected a TV to both the
MAIN and SUB jacks.
MAIN To output Dolby Vision video to a Dolby Vision-supported TV
connected to the HDMI OUT MAIN jack
SUB To output Dolby Vision video to a Dolby Vision-supported TV
connected to the HDMI OUT SUB jack
O After selecting "MAIN" or "SUB", if the video on the TV does
not appear correctly
Upscaling (Default Value: O)
When a TV supporting 4K/8K is used, video signals input with 1080p can be
automatically output with 4K/8K. Video signals that are input at 4K can also
automatically be output as 8K. Note that to output as 8K, set "HDMI 4K/8K
Signal Format" ( →p130) to "8K Standard" or "8K Enhanced", and you need to
connect to a TV that is compatible with the 8K signal format with an HDMI cable.
• If the TV does not support the 4K/8K resolution with the same frequency
as the frequency of HDMI input video signals, upscaling to 4K or 8K is not
correctly performed. Check the frequency of 4K/8K resolution supported
by the TV, and change the resolution of the video signals input from the AV
component.
O When this function is not used
• If your TV does not support 4K/8K, set it to "O".
Auto When this function is used
Super Resolution (Default Value: 2)
When "Upscaling" is set to "Auto", select the correction level of the input video
signals from "O" and "1" (weak) to "3" (strong).
To Next Page
Loading...
Need help?
General
