EasyManuals Logo

Integra DRX-8.4 User Manual

Integra DRX-8.4
218 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #141 background imageLoading...
Page #141 background image
141
SetupSetup
2. Speaker
7. THX Audio
Change the THX Audio settings.
Back Speaker Spacing (Default Value: >4.0 ft/>1.2 m)
Select the distance between the surround back speakers from "<1.0 ft/<0.3 m",
"1.0 - 4.0 ft/0.3 - 1.2 m", and ">4.0 ft/>1.2 m".
The unit of distance (ft/m) is displayed using the unit selected for the
"Distance" setting.
The setting cannot be changed if "Conguration" - "Zone Speaker" is set to a
selection item other than "No" and Zone 2 is on.
If the item cannot be selected even though connection is correct, check if
the setting in "Conguration" - "Speaker Channels" matches the number of
connected channels.
THX Ultra / Select Subwoofer (Default Value: No)
Set whether a THX-certied subwoofer is connected or not.
This cannot be selected if "Conguration" - "Subwoofer Preout" or "Passive
Subwoofer" is set to "No".
Yes When a THX-certied subwoofer is connected
No When a THX-certied subwoofer is not connected
BGC (Default Value: O󰀨)
Correct an emphasized bass sound when listening to music near the wall or
boundary of the room due to layout limitation of the listening room. The THX
Select receivers can adjust the balance of bass sound.
In the following cases, the setting cannot be changed:
"Conguration" - "Subwoofer Preout" or "Passive Subwoofer" is set to "No".
"THX Ultra / Select Subwoofer" is set to "No".
One of the slots has been selected with "Dirac Live" ( p93).
On When this function is used
O󰀨 When this function is not used
Loudness Plus (Default Value: On)
This cannot be selected when either of the slots is selected with "Dirac Live"
( p93).
When this is set to "On", you can enjoy even subtle nuances of audio
expression at low volume. This is only available when the THX listening mode
is selected.
THX Loudness Plus
THX Loudness Plus is a new volume control technology mounted on THX Ultra
and THX Select-certied receivers. With THX Loudness Plus, home theater
audience can experience the rich details of surround sound at any volume
level.
If the volume is turned down below the reference level, elements of sound in a
certain range are lost or the sound is perceived di󰀨erently by the listener.
THX Loudness Plus compensates for the tonal and spatial shifts that occur
when the volume level is reduced, by intelligently adjusting the levels of the
surround channels and their frequency response in the environment.
This enables users to experience the true impact of soundtracks regardless of
the volume setting. THX Loudness Plus is automatically applied when listening
in any THX listening mode. In the newly developed THX Cinema, THX Music
and THX Games modes, the optimum THX Loudness Plus setting is applied
according to the type of content.

Table of Contents

Other manuals for Integra DRX-8.4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Integra DRX-8.4 and is the answer not in the manual?

Integra DRX-8.4 Specifications

General IconGeneral
Channels11.2
Amplification TypeClass AB
THD+N0.08%
HDMI Inputs7
HDMI 2.1Yes
HDR SupportHDR10, Dolby Vision, HLG
eARCYes
Phono InputYes
Zone 2/3 Powered OutputsYes
USB Input1 (Front)
EthernetYes
Wi-FiYes
BluetoothYes
Standby Power Consumption0.15 W
Power Output (8 Ohms, 20 Hz-20 kHz, 0.08% THD, 2 Channels Driven, FTC)140W
Power Output (6 Ohms, 1 kHz, 10% THD, 1 Channel Driven)250 W/Ch
Input Sensitivity and Impedance200 mV/47 kOhms (Line)
Signal-to-Noise Ratio106dB
Speaker Impedance4 Ohms – 16 Ohms
HDMI Outputs3
Digital Audio InputsOptical: 2, Coaxial: 1
Pre-Outs11.2 Ch
Speaker Terminals11
Streaming ServicesAirPlay 2, Spotify, Tidal, Deezer
Voice ControlAmazon Alexa, Google Assistant
Room CorrectionAccuEQ
Supported Audio FormatsDolby Atmos, DTS:X
Weight14.5 kg (32 lbs.)

Related product manuals