93
Playback
Room EQ
Dirac Live (*1): You can select the slots with registered lters measured with
Dirac Live ( →p170, p174) from "Slot1" to "Slot3".
• The Dirac Live measurement results are saved in "Slot1" to "Slot3", but you
are able to register your own original lter with "Manual Adjust" ( →p176).
• This cannot be selected when measurements are made using "AccuEQ
Room Calibration".
AccuEQ (*1)(*2): Enable or disable the equalizer function that corrects for
sound distortion caused by the acoustic environment of the room.
On (All Ch): EQ that corrects according to the room acoustics acquired with the
AccuEQ calibration is applied to all channels.
On (ex. L/R): The same EQ as "On (All Ch)" is applied to speakers other than the
Front Speakers. EQ correction for the Front Speakers is turned o.
On (F.MatchEQ): For speakers other than the front speakers, an EQ is applied
that suits the characteristics of the front speakers.
• The setting can be separately set to each input selector.
Manual Equalizer (*1)(*2): Select "Preset 1" to "Preset 3" congured in
"Speaker" - "Equalizer Settings" on the Setup menu. When this is set to "O",
the same sound eld setting is applied to all ranges.
Re-EQ, Re-EQ(THX) (*1)(*2): Adjusts the soundtrack with the enhanced high
range so that it suits a home theater.
The following listening modes can be used for Re-EQ: Dolby Audio - DD, Dolby
Audio - DD+, Dolby Audio - Surr, Dolby Audio - TrueHD, Multichannel, DTS,
DTS-ES, DTS 96/24, DTS-HD High Resolution Audio, DTS-HD Master Audio,
DTS Neural:X, DTS Express and DSD
In Re-EQ(THX), the following listening modes can be used: THX Cinema and
THX Select Cinema
EQ for Standing Wave (*1)(*2): Setting this "On" will control the eect of
the standing wave generated by the sound wave reected by wall or similar
interfering with the original sound wave.
(*1) It cannot be set if the listening mode is Direct.
(*2) This function cannot be used if Dirac Live ( →p170, p174) is being used.
Furthermore, there is no eect even if it can be selected.
Level
Front: Adjust the speaker level of the front speakers while listening to the sound.
Center: Adjust the speaker level of the center speaker while listening to the
sound.
Subwoofer 1/Subwoofer 2: Adjust the speaker level of the subwoofer while
listening to the sound.
• If you set the unit to the standby mode, the adjustments you made will be
restored to the previous statuses.
To Next Page
Loading...
Need help?
General
