189
Troubleshooting
ZONE B function
Cannot output audio to ZONE B
• To output audio to ZONE B, set the audio output destination for "Audio" - "Zone B" on Quick menu to "On (A+B)" or "On (B)" and also set
"Speaker" - "Conguration" - "Zone 2 Preout" on the Setup menu to "Zone B".
( →p123)
Multi-zone function
Cannot ZONE-output the audio of externally connected AV components
• If the AV component is not equipped with an HDMI jack, use a digital coaxial cable, digital optical cable or analog audio cable. Also, the audio
from externally connected AV components can be output to ZONE 2 only when the audio is analog or 2 ch PCM signal. When the AV component
is connected to this unit with an HDMI cable, digital coaxial cable or digital optical cable, change the audio output of the AV component to the
PCM output.
• When video and audio via HDMI input are output to ZONE 2, set "Input/Output Assign" - "TV Out / OSD" - "Zone 2 HDMI" ( →p130) to "Use"
on the Setup menu.
• To output audio from an externally connected AV component to ZONE 3, use an analog audio cable for connection. Also, audio from externally
connected AV components can be output to ZONE 3 only when it is an analog audio signal.
Others
• If the audio signal is from the NET input selector, the zone output is not possible for DSD audio signals.
Remote Controller
• Make sure that the batteries are inserted with the correct polarity.
• Insert new batteries. Do not mix dierent types of batteries, or old and new batteries.
• Make sure that the sensor of the main unit is not subjected to direct sunlight or inverter-type uorescent lights. Relocate it if necessary.
• If the main unit is installed in a rack or cabinet with colored-glass doors, or if the doors are closed, the remote controller may not work normally.
Display
The display does not light up
• When the Dimmer function is working, the display may go dim. Press the Dimmer button, and change the brightness level of the display. ( →p18)
To Next Page
Loading...
Need help?
General
