77
Zone 2—Continued
Adjusting the Tone and Balance of Zone 2
Notes:
• Only analog input sources are output by the ZONE 2
PRE OUT. Digital input sources are not output. If no
sound is heard when an input source is selected, check
if it’s connected to an analog input.
• While Zone 2 is on, u functions will not work.
• You cannot select different AM or FM radio stations
for your main room and Zone 2. The same AM/FM
radio station will be heard in each room. For example,
if you have an FM station for the main room, that sta-
tion will also be used in Zone 2.
• Zones can also be unmuted by adjusting the volume.
• The Zone 2 level, balance, and tone functions have no
effect on the ZONE 2 PRE OUT when the “Z2 Out”
setting is set to “Fixed” (page 74).
1
AV receiver
On the AV receiver, press the
[Zone 2] button.
2
Press the AV receiver’s [Tone]
button repeatedly to select
“Bass”, “Treble” or “Balance”.
3
Use the Tone Plus [+] and Minus
[–] buttons to adjust the Bass,
Treble or Balance.
• You can boost or cut the Bass or Tre-
ble from –10 dB to +10 dB in 2 dB
steps.
• You can adjust the balance from 0 in
the center to +10 dB to the right or
+10 dB to the left in 2 dB steps.
Zone 2
Tone
,
70_Zone2_En.fm 77 ページ ２００９年４月９日 木曜日 午前９時２９分
To Next Page
Loading...
