Intel® Server Board S1200V3RP TPS BIOS Setup Interface
Revision 1.2
Help Text:
User password is used if Power On Password is enabled and to allow restricted access
to BIOS Setup. Length is 1-14 characters. Case sensitive alphabetic, numeric and
special characters !@#$%^&*()-_+=? are allowed.
Note: Removing the administrator password also removes the user password.
Comments: The User password is available only if the Administrator Password
has been installed. This option protects Setup settings as well as boot choices. The User
Password only allows limited access to the Setup options, and no choice of boot devices.
When Power On Password protection is enabled, the User password may be used to
allow the BIOS to complete POST and boot the system.
The password format and entry rules and popup error and warning message are the
same for the User password as for the Administrator password (see above).
Back to [Security Screen] — [Screen Map]
5. Power On Password
Option Values: Enabled
Disabled
Help Text:
Enable Power On Password support. If enabled, password entry is required in order to
boot the system.
Comments: When Power On Password security is enabled, the system will
halt soon after power on and the BIOS will ask for a password before continuing POST
and booting. Either the Administrator or User password may be used.
If an Administrator password has not been set, this option will be grayed out and
unavailable. If this option is enabled and the Administrator password is removed, that will
also disable this option.
Back to [Security Screen] — [Screen Map]
6. Front Panel Lockout
Option Values: Enabled
Disabled
Help Text:
If enabled, locks the power button OFF function and the reset and NMI Diagnostic
Interrupt buttons on the system’s front panel. If [Enabled] is selected, power off and reset
To Next Page
Loading...
Need help?
General
