Intelbras TI 5000 - Page 76

76
Programmable key conguration:
1. To congure, press the Menu selection key and, using the keys or , select the Features option;
2. Using the keys , move the cursor to Motion Sensor and press Ok;
3. After entering the indicated menu, access the “Programmable key Conf. ” option and press the Ok key;
4. After the message “Choose the programmable key” appears on the display, press the desired programmable key. The
message “Programming successfully done” will appear on the display.
5. Press the shortcut key where you programmed the motion sensor to activate it.
¹ If your product has a motion sensor.
Timing
It is possible to congure the entry and exit times of the motion sensor’s detection zone. These times are used to counteract
the triggering after Activation or during Deactivation, without an unwanted triggering occurring.
Setting the trigger times:
1. In Motion Sensor , move the cursor with the keys or to Timings option and press Ok ;
2. Congure the time to Deactivate After * and Activate After * (between 0 and 99 seconds) using the numeric keypad;
3. Once congured, press Ok.
Note: » Activate after: time to leave the detection zone without triggering the alarm.
» Deactivate after: time to enter the detection zone without triggering the alarm.
Alarm Activation
There are four alarm trigger options, Send SMS message, External action, Dial number, Ring terminal. It is possible to
program up to 3 trigger options simultaneously, but the Dial number and Ring terminal options cannot be congured
together. When more than one option is enabled, the activation of the alarms will occur sequentially in 5 second
intervals.
Triggers Conguration
1. In Motion Sensor , move the cursor with the keys or to the Alarm Trigger option and press Ok ;
2. Congure the desired triggers using the ,,, keys and the alphanumeric keypad.
To cancel a setting that has already been programmed, select the option present in the Alarm Trigger menu and press the
Delete selection key.
Note: SMS messaging is only possible when the terminal is connected to Impacta exchanges that have GSM cards.
Access Password
The password conguration present in the Motion Sensor menu serves to protect the deactivation of the sensor. To activate
the motion sensor password, the extension’s password must already be programmed.
Conguration to enable the motion sensor password:
1. In Motion Sensor, move the cursor with the or keys to the Extension Password option and press Ok ;
2. Enable or disable the password using the keysor;
3. Once congured, press Ok.
Using the motion sensor
After conguring the programmable key, the activation times, and the types of triggers, you can use the motion sensor. To
activate it press the programmable key congured for this function. At this moment the message Motion Sensor Activated
will be displayed.
When the motion sensor is activated the LED on the programmable key ashes, indicating that the function is active.
After the sensor is activated it is possible to leave the detection zone for the time congured in the option Activate
after.
When motion is detected, the LED on the programmable key changes state to ON and starts executing the pre-
programmed triggers.
To deactivate the triggering, simply press the programmable key again to unlock the function.
Note: with the function active the TI 5000 keyboard is locked. To use the terminal normally again, press again the key
programmed for the function.