Intelbras TI 5000 - Beep Volume Configuration; Headset Configuration; Force Headset Detection; Programmable Keys Configuration

81
» (One beep every 3 seconds): occurs when the handset is left off-hook. If the handset is not on-hook, after 2
minutes the beeps will sound.
Factory default: mute.
» (Three beeps): these happen when there is an alarm present. The alarm occurs when the exchange in
which the terminal is installed changes from day to night state.
Factory default: low volume.
» (Four beeps followed by a pause that can be repeated up to 20 times): This happens when
there is a reminder programmed for this time.
Factory default: loud volume.
When the terminal is programming, in the phone book or viewing the call list, the only possible beeps are: key pressed beep
and reminder beep. If the terminal is monitoring the environment, no beeps will be generated. Only the terminal installed
at an operator extension will receive alarm beeps.
10.5. Beep volume conguration
Procedure
1. Press the Menu key. The terminal will enter the main menu;
2. Search for Prole using the keys and . Press the Ok key;
3. Search for Audible Alert and press the Ok key;
4. Look for one of the following audible alert options to congure:
» Pressed key.
» Off-hook handset.
» Reminder notication.
» Alarm Present.
» Incoming message notication.
5. Press the Ok key;
6. Press the key and to choose the desired level: high, low and mute;
7. Press the Ok key to conrm the setting or the key if you do not want to conrm the setting.
10.6. Headset conguration
Allows you to congure the terminal to operate with the headset with or without a boom. Differentiated by the sensitivity of the
microphone.
1. Press the Menu key. The terminal will enter the main menu;
2. Search for Prole using the keys and . Press the Ok key;
3. Search for Headset conguration and press the Ok key;
4. Select one of the options: without boom or with boom and press the Ok key to congure.
Factory default: with boom .
10.7. Force headset detection
This setting must be enabled if the headset is connected to the terminal and is not automatically recognized.
1. Press the Menu key. The terminal will enter the main menu;
2. Search for Prole using the keys and . Press the Ok key;
3. Search for Force headset det. and press the Ok key;
4. Select the Enable/Disable option and press the Ok key.
10.8. Programmable keys conguration
You can congure the programmable keys by associating each one with a specic function.
Procedure
1. Press the Menu key. The terminal will enter the main menu;
2. Search for Programmable Keys and press the Ok key;
3. Select between Congure Key or Congure Range ;
4. The Choose Programmable Key or Choose Initial Programmable Key will be displayed.;