Interacoustics Sera - Quick test; General; Saving a quick test

D-0112389-I – 2022/04
Sera™ - Instructions for Use - EN Page 50
4.9 Quick test
4.9.1 General
Selection of Quick Test f rom the Home screen bypasses entry of patient
information or selection of a patient from the database.
The process of a Quick Test is identical to that of a standard test.
Quick tests can be printed immediately after the test is completed, but no identifying inf ormation will appear
on the print-out.
Only the last Quick Test session is saved temporarily in the Sera
TM
until the next time that the Quick Test
button is selected on the Home screen. When Quick Test is selected, the previous Quick Test session is
immediately and permanently deleted from Sera
TM
.
Please note: Quick test f unctionality can be enabled/disabled by an Administrator via HearSIM
TM
. If Quick
Test is disabled on your device, then the Quick Test button will not appear on the Home screen.
4.9.2 Saving a quick test
If it is your standard practice to save screening tests, it is highly recommended that you first enter the patient
information or select an existing patient in the database before performing the screening.
However, if you want to save a Quick Test session (all tests) immediately after it was performed, f ollow these
steps:
1. At the Home screen, choose Select Patient
2. Select the “Quick Test” patient
3. Edit the patient’s data in the Patient Information screen
4. Select the Checkmark in the bottom control bar
The Quick Test session is now saved under the patient ID and name you entered.