D-0112389-I – 2022/04
Sera™ - Instructions for Use - EN Page 66
To clean the larger channel, it is advisable to double the floss to
effectively clean all corners.
To access and clean the larger channel, it is necessary to remove the
gasket from inside the probe tip. You can do this using a f ine pin.
Push the gasket back into place af ter cleaning.
Reattach the probe tip to the probe and screw the gasket into place.
DO NOT try to clean the probe tip while it is mounted on the probe.
Only insert the cleaning f loss or wire into the base of the probe to
ensure wax/debris is pushed out of the probe tip instead of into it. This
also protects the gasket from being damaged. Never use tools to affix
the probe cap!
Please refer to the Sera
TM
Additional Information for further information about Cleaning of the
probe.
To Next Page
Loading...
