Intermec EasyCoder C4 - Page 18

Intermec EasyCoder C4 – Programmer’s Guide Ed. 3 17
Chapter 5 Editing in Form Edit Mode
Example, cont.
Draw a Box and two Lines
Start to draw the surrounding box using the X command and then
draw the two lines using the LO command.
Command Explanation
X0,0,4,752,584↵ Draw a box
LO0,144,752,4↵ Draw a black line
LO440,232,4,160↵ Draw a black line
Place a Text Line with Fixed Data
Enter a 90° rotated text line containing the fi xed data "Made in
Sweden" in text size 1. The quotation marks enclosing the fi xed
data will not be printed. The text size (1) is the smallest resident
font in the printer.
Command Explanation
A40,400,1,1,1,1,N,"Made in Sweden"↵ 90 degree. text line, fi xed data
Place a Variable Text
The next line is a text line, using text size 5 in reverse and prints the
variable V00. The data printed in this fi eld must be sent to the printer
at the time of form retrieval.
Command Explanation
A24,160,0,5,1,1,R,V00 ↵ Write a text line, 1:st variable
Place a Combination of Fixed Data and a Variable
The following two command lines consist of a combination of fi xed
data enclosed in quotation marks and variable data.
Command Explanation
A24,250,0,4,1,1,N,"MODEL: "V01↵ Text line, fi xed data + 2:nd variable
A472,312,0,4,1,1,N,"Checked by: "V02↵ Text line, fi xed data + 3:rd variable