Intermec EasyCoder C4 Programmer's Guide

Intermec EasyCoder C4 – Programmer’s Guide Ed. 3 18
Chapter 5 Editing in Form Edit Mode
Example, cont.
Place a Combination of Fixed Data and a Counter
The next command line is a text line containing fi xed data and the
counter (C0). The fi rst time this label form is retrieved for printing,
the start value for this counter must be sent to the printer. The printer
will store the value of the counter for this form and automatically
continue to print the next value the next time this form is retrieved.
Reset or set to another value by sending a new start value.
Note: The value of the counter will be kept in the memory even
if another form is retrieved but will be lost if the printer is
switched off.
Place a Bar Code with Fixed Data and a Counter
Below Bar Code Command line is entering a Code 128 bar code,
containing the fi xed data "S" in combination with the actual counter
value. It is also set for printing the human readable text below
the bar code.
Note: The narrow to wide ratio is not relevant for Code 128. The
printer will use the value for the narrow bar to defi ne the bar code.
(Value 3 for wide bar defi nition is ignored).
Place Graphics
The next line writes a graphic named “Intermec” from memory
and positions it on the form.
End Programming of this Form
The closing command that fl ags the end of form, see the full program
listing later in this chapter.
On next page, there is a complete list of this example.
Command Explanation
A24,312,0,4,1,1,N,"SERIAL#: "C 0↵ Text line, fi xed data + 1:st counter
Command Explanation
B280,440,0,1,2,3,96,B,"S"C 0↵ Bar code, fi xed data + 1:st counter
Command Explanation
GG24,12,"LOGO"↵ Write graphic from graphics memory
Command Explanation
FE↵ Closing command to store form

Intermec EasyCoder C4 Specifications

General

Brand	Intermec
Model	EasyCoder C4
Category	Printer
Language	English