Intermec EasyCoder PD41 Service Manual

Before You Begin
EasyCoder PD41/PD42 Printer Service Manual vii
Before You Begin
This section provides you with safety information, technical support
information, and sources for additional product information.
Safety Summary
Your safety is extremely important. Read and follow all warnings and
cautions in this document before handling and operating Intermec
equipment. You can be seriously injured, and equipment and data can be
damaged if you do not follow the safety warnings and cautions.
Do Not Repair or Adjust Alone
Do not repair or adjust energized equipment alone under any
circumstances. Someone capable of providing first aid must always be
present for your safety.
First Aid
Always obtain first aid or medical attention immediately after an injury.
Never neglect an injury, no matter how slight it seems.
Resuscitation
Begin resuscitation immediately if someone is injured and stops breathing.
Any delay could result in death. To work on or near high voltage, you
should be familiar with approved industrial first aid methods.
Energized Equipment
Never work on energized equipment unless authorized by a responsible
authority. Energized electrical equipment is dangerous. Electrical shock
from energized equipment can cause death. If you must perform
authorized emergency work on energized equipment, be sure that you
comply strictly with approved safety regulations.
Sicherheitsübersicht
Ihre Sicherheit ist äußerst wichtig. Lesen und befolgen Sie alle Warn- und
Vorsichtshinweise in diesem Dokument, bevor Sie Intermec-Geräte
verwenden und betreiben. Falls die Sicherheitswarnungen und
Vorsichtshinweise nicht befolgt werden, kann es zu ernsthaften
Verletzungen sowie Geräteschäden und Datenverlusten kommen.
Nicht alleine Reparaturen oder Einstellungen durchführen
Reparieren oder justieren Sie niemals alleine stromführende Geräte. Aus
Sicherheitsgründen muss eine zweite Person anwesend sein, die erste Hilfe
leisten kann.

Intermec EasyCoder PD41 Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Power requirements	100-240 VAC ±10%, 45-65 Hz
Media thickness	2.3 - 9.8 mm
Maximum label width	104 mm
Maximum label length	0.15 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Depth	453 mm
Width	273 mm
Height	270 mm
Weight	13000 g