Invacare Spree XT - Typical Product Parameters

TYPICAL PRODUCT PARAMETERS
Part No 1118364 15 Spree XT
TYPICAL PRODUCT PARAMETERS
NOTE:Measurementsbasedona16‐inchwideby16‐inchdeepwheelchairwith12‐inchrear
wheelsand4‐inchcasters.
*NOTE:Theseat‐to‐floorheightsarebasedonpneumatictiresandpneumatictireswithflatfree
inserts.Ifwheelchairisequippedwithurethanetires,subtract1/4‐inchfrom
themeasurements
listedabove.Allheightsaremeasuredwithproperlyinflatednewtires.Theseheightscanvary
+
1/4‐inchduetotirewear.
INVACARE SPREE XT
Overall Width:
Open: Seat Width Plus Approximately 9-inches
Closed: Approximately 14-inches
Overall Depth:
(W/O Front Riggings)
29-1/2-inches
Overall Height:
* Seat-to-Floor Height + 21-inches (20-inch back canes
* Seat-to-Floor Height + 25-inches (24-inch back canes
Anti-Tippers:
Standard
Footrest:
Swing-Away Footrest - 90° (Standard), 70° or 60°, Lift-off Footrest
(Optional), Elevating Legrests (Optional)
Armrests:
Locking Cantilever Arms - Desk or Full Length
Non-Locking Cantilever Arms
T-Arms - Desk or Full Length, Adjustable Height
Back:
Fixed - 20 or 24-inches
Back Angle Adjustment:
86° to 106° (4° increments)
Rear Axle:
Quick-Release or Permanent
Rear Wheels:
12-inches Pneumatic (Standard)
12-inch Pneumatic w/flat free (Optional)
20, 22 and 24-inch Pneumatic, Urethane, Pneumatic w/flat free, Primo or
KIK® (Optional)
Handrims:
Aluminum Handrims (20, 22 and 24-inch)
Caster Size:
3 x 1, 5 x 1, 6 x 1 Urethane (Optional)
4 x 1 Light Up (Standard)
4 x 1, 5 x 1 Semi-Pneumatic (Optional)
6 x 2-inch w/ Precision Sealed Bearings (Optional)
8-inch w/ Precision Sealed Bearings (Optional)
6 x 1-inch w/ Precision Sealed Bearings (Optional)
Seat Width:
10-12, 12-14, 14-16, 16-18, 18-20-inches wide
Seat Depth:
12 to 16-inches (with 2-inch seat rail extension)
12 to 20-inches (with 2-inch seat rail extension)
Back Cane Height:
20 and 24-inches
Wheel Locks:
12, 20, 22, and 24-inch Rear Wheels - Push to Lock, Pull to Lock, Hill
Holder
Tilt-In-Space:
Dual Cable Trigger Mechanism (Standard) - 45° Tilt
Frame:
Aluminum
Weight Limitation:
150 lbs.