Invacare Spree XT - Installing;Removing Stroller Handles

SECTION 6—BACK/SEAT
Spree XT 54 Part No 1118364
Installing/Removing Stroller Handles
NOTE:Forthisprocedure,refertoFIGURE6.3.
Installing Stroller Handles
1. Removetheplugbuttonsfrombothbackcanes,ifnecessary.
2. Slidethestrollerhandleintothebackcanes.
3. Alignthemountingholesofthestroller
handleandthebackcanes.
4. Pressthebuttononthequick‐release
pinandinsertthequick‐releasepin
throughthebackcaneandstroller
handle.
5. Releasethebuttononthequick‐release
pin.
6. Pullonthestrollerhandletomakesure
itislockedsecurelyinplace.
FIGURE 6.3 Installing/Removing Stroller
Handles
Removing Stroller Handles
1. Pushinthebuttonsofthequick‐releasepins.
2. Pulloutthequick‐releasepinsthatsecurethestrollerhandletothebackcanes.
3. Removethestrollerhandlefromthewheelchair.
4. InstalltheNEWstrollerhandleifdesired.RefertoInstallingStrollerHandleson
page 54.
Back Cane
Mounting
Holes
Stroller Handle
Button
Quick-Release Pin