Invacare Spree XT - Adjusting Non-Locking Cantilever Arm Height; Adjusting Non-Locking Cantilever Arm Angle

SECTION 5—ARMS
Spree XT 46 Part No 1118364
Adjusting Non-Locking Cantilever Arm Height
NOTE:Forthisprocedure,refertoFIGURE5.5.
1. Removethelocknutandwasherfromthelowerhexboltsecuringthecantileverarm
tothebackcane.
2. Slidethecantileverarmassemblyoutofthebackcane.
3. Repositionthecantileverarmassemblytothedesiredmountinghole.
4. Securethecantileverarmtothewheelchairwithawasherandlocknut.
Adjusting Non-Locking Cantilever Arm Angle
NOTE:Forthisprocedure,refertoFIGURE5.6.
1. Loosenthemountingscrewsecuringthecamtothecantileverarm.
2. Rotatethecamuntilthedesiredangleisachieved(DetailʺBʺ).
3. Tightenthemountingscrewsecuringthecamtothecantileverarm.
FIGURE 5.6 Adjusting Non-Locking Cantilever Arm Angle
12° Arm Angle
DETAIL “B” - CAM POSITIONS
Cantilever
Arm
Back
Cane
Cam
Back Cane
Cantilever Arm
Back
Cane
Cam
Back
Cane
Cam
Back
Cane
Cam
Back
Cane
Cam
Back
Cane
Cam
0° Arm Angle 4° Arm Angle 8° Arm Angle
16° Arm Angle
Side View of Cam
NOTE:Allarmanglesarerelativetothebackcane.