If IP Address Type is set to DHCP, you should log in to the web UI of the
AP using the AP’s IP address assigned by the DHCP server. To get the AP’s
IP address, find it in the client list of the DHCP server.
IP Address
It specifies the IP address of the AP (default: 192.168.0.254). You can
access the web UI of the AP using this IP address.
Subnet Mask
It specifies the subnet mask of the IP address of the AP. The default
subnet mask is 255.255.255.0.
Default Gateway
It specifies the gateway IP address of the AP.
Generally, to ensure that the AP can access the internet successfully, you
should set the gateway IP address to the LAN IP address of the router
connected to the internet.
Primary DNS
Server
It specifies the IP address of the primary DNS server of the AP.
If DNS proxy function is supported on your router connected to the
internet, you can set the IP address of the primary DNS server to the LAN
IP address of your router. Otherwise, enter a correct DNS server IP
address.
Secondary DNS
Server
It specifies the IP address of the secondary DNS server of the AP. This
parameter is optional.
Device Name It specifies the name of the AP.
Ethernet Mode
−
Auto Negotiation: In this mode, this device can be powered through
the LAN port using a CAT 5e or better Ethernet cable with a maximum
transmission distance of 100 meters.
−
10 Mbps Half Duplex: In this mode, this device can be powered
through the LAN port using a CAT 5e or better Ethernet cable with a
maximum transmission distance of 150 to 200 meters.
28
To Next Page
Loading...
