Wireless Access Point
User Guide
1.2.2 Bottom label
The bottom label shows the AP’s default IP address, login username and password, input DC
power supply, and serial number. See the following figure:
IP Address: It specifies the default IP address of the AP. You can use this IP address to log in
to your AP’s web UI when you set it for the first time. After you change the IP address, you
should use the new IP address to log in to its web UI.
Username/Password: It specifies the default login username/password used to log in to the
web UI of the AP. After you change the username/password, you should use the new
username/password to log in to its web UI.
Power: It specifies the input DC power supply of the AP.
S/N: It specifies the serial number of the AP. If the AP is faulty, you need to provide this serial
number for repair.
To Next Page
Loading...
