IPETRONIK IPEmotion PlugIn IPETRONIK-X - Page 29

X-LINK modules
IPETRONIK PlugIn X V02.14.00
IPETRONIK GmbH & Co. KG
28/ 87
SENS-Mode
IN+
0.2M
0.2M
4M8
4M8
IN-
+0.5/ +1.25/ +2.5/ +5 V
+10/ +12/ +15 V
Unipolar
5/ 10/ 20/ 50 V
Bipolar
10/ 20/ 50 V±5/ ± ± ±
-0.5/ -1.25/ -2.5/ -5 V
-10/ -12/ -15 V
GND
GND
+SENS
-SENS
+VOUT
-VOUT
+
-
Potentiometer Potentiometer
dual supply single supply
Measurement Input
Applications
 Measurement with sensors without a direct ground (GND) reference
 Voltage measurement up to ±50 V
Features
 Sensor connection supporting 3-wire and 4-wire technique
 Sensor break detection for the 4 wires (IN, VOUT)
indication by output of –Full Scale
Measurement ranges
 0.01 / 0.02 / 0.05 / 0.1 / 0.2 / 0.5 / 1 / 2 / 5 / 10 / 20 / 50 V
 ±0.01 / ±0.02 / ±0.05 / ±0.1 / ±0.2 / ±0.5 / ±1 / ±5 / ±10 / ±20 / ±50 V
Adjustable differential voltages (hardware adjust)
SENS measurement ranges
SENS adjust ranges
unipolar
bipolar
5 V
±5 V
±2.25 V
10 V
±10 V
±4.50 V
20 V
±20 V
±9.00 V
50 V
±50 V
±22.50 V
Common Mode Rejection Ratio (CMRR)
To guarantee a correct measurement of the input signal over the complete measurement range (uncropped
signal amplitude), the input voltage on IN+ resp. IN- relating to the GND potential should not exceed the
limits listed in the table below.