4210 Flow Meter
Section 2 Programming
2-12
Then:
And:
Finally:
If you select SET CLOCK, the following will appear:
Enter the year (four digits), the month (01-12), the day (01-31),
the hour (01-24), and the minute (01-59).
If you select SITE ID, the following will appear:
You can select any suitable three-digit number for the site identi-
fication.
If you select MEASUREMENT SETUP, the following will appear.
You will have to use the right arrow key to bring all the options
on screen:
LEVEL READING INTERVAL refers to how often the flow meter
takes a level reading. LEVEL refers to the level in the flow
stream.
DO/PH READING INTERVAL refers to the measurement of spe-
cific aspects of the flow stream other than amount. The 4210 sup-
ports measurement of three different characteristics:
temperature, pH (the relative acidity or alkalinity of a
solution), and D.O., dissolved oxygen.
VARIABLE BLANKING refers to the ability of the flow meter to
ignore certain measurements of the ultrasonic transducer to
reduce the possibility of error.
YSI 600 READING INTERVAL refers to the frequency of mea-
surements made by the YSI 600 Sonde.
If you select LEVEL READING INTERVAL, the following will
appear:
SETUP OPTIONS: 'EXIT' TO QUIT
• OPTIONAL OUTPUTS • • REPORT SETUP •
SETUP OPTIONS: 'EXIT' TO QUIT
• LCD BACKLIGHT • • (LANGUAGE) • • PROGRAM LOCK •
SETUP OPTIONS: 'EXIT' TO QUIT
• (LANGUAGE) • • PROGRAM LOCK • • PROGRAM •
YEAR MONTH DAY HOUR MIN
XXXX XX XX XX XX
SITE ID: XXX
MEASUREMENT SETUP
• LEVEL READING INTERVAL • • DO/PH READING INT-
MEASUREMENT SETUP
• DO/PH READING INTERVAL • • VARIABLE BLANKING •
MEASUREMENT SETUP
• VARIABLE BLANKING • • YSI 600 READING INTERVAL •
LEVEL READING INTERVAL
•CONTINUOUS••15 SEC••30 SEC••1 MIN••2 MIN••5 MIN•
To Next Page
