4210 Flow Meter
Section 2 Programming
2-25
Press Enter and the SETUP menu will reappear.
PROGRAM will be flashing. (Note that PROGRAM is always the
default choice. That is because you are more likely to need to
make changes in the PROGRAM section of the software than in
the SETUP section.)
Note
If you choose NOT MEASURED for any selection, the flow
meter will make no further reference to that function for the rest
of the program, and you will be unable to activate that function
later. If there is a feature you need that does not appear when
the manual says it should, return to step 1 and make sure you
have not accidentally left it turned off.
If you program a parameter value as a condition for sampler
enabling, pacing, dialout, etc., and then turn that parameter
sensor off, the flow meter will also remove that condition from
the program.
Consider all aspects of your program before you make
any changes.
Press Enter. The following will appear:
Selection of feet, inches, meters, or mm depends on your situ-
ation. You would select NOT MEASURED if you were using the
flow meter for some other form of sensing only, such as pH or
temperature. Press Enter. The following will appear. You will
have to press the right arrow key several times to see all of the
options displayed below:
Pressing the right arrow key several times will move other
units onto the display:
NOT MEASURED will also appear if you keep moving with the
right arrow key. This step establishes the units of measure the
flow meter will use in all subsequent displays and calculations.
GPS = gallons per second; GPM = gallons per minute; GPH =
gallons per hour; MGD = millions of gallons per day; CFS = cubic
feet per second; CFM = cubic feet per minute; CFH = cubic feet
per hour; CFD = cubic feet per day; LPS = liters per second; M3S
= cubic meters per second; M3M = cubic meters per minute; M3H
= cubic meters per hour; M3D = cubic meters per day; AFD =
acre-feet per day.
SELECT OPTION
• PROGRAM • • SETUP •
UNITS OF LEVEL MEASUREMENT
• FT • • IN • • M • • MM • • NOT MEASURED •
FLOW RATE UNITS OF MEASURE
• GPS • • GPM • • GPH • • MGD • • CFS • • CFM • • CF-
FLOW RATE UNITS OF MEASURE
• CFH • • CFD • • LPS • • M3S • • M3M • • M3H • • M3D • • AFD •
TOTALIZED VOLUME UNITS
• GAL • • MGAL • • CF • • L • • M3 • • AF •
To Next Page
Loading...
