4210 Flow Meter
Section 2 Programming
2-52
After you have entered the desired date and time for the first
report, the program will advance to the following:
The final programming choice is HISTORY. This presents a
record of the programming activity on the flow meter that you
can have printed by the plotter. The flow meter keeps a record of
certain programming changes and prints them out. If you select
YES, the following will appear:
If you press PRINT SINCE LAST, the flow meter will only print
the changes that have occurred since the last print request. If
there were no changes, there will be no print. If you select PRINT
ALL, the flow meter will print all the changes it has in memory,
as far back as fifty entries.
If you selected NO from PRINT FLOW METER HISTORY, the
flow meter will advance to CLEAR HISTORY - YES/NO.
If you select NO again, the flow meter will exit programming and
return to the normal display. If you clear the memory, previous
programming changes will be erased, but the flow meter will
begin tracking changes again the next time you change the
program.
Flow Meter History Contents:
D. O. ADJUSTED
pH ADJUSTED
LEVEL ADJUSTED
FLOW CONVERSION CHANGED
PLOTTER SPEED CHANGED
PLOTTER TURNED ON
PLOTTER TURNED OFF
TIME CHANGE FROM
TIME CHANGE TO
REPORT A CHANGED
REPORT B CHANGED
REPORT A TURNED ON
REPORT B TURNED ON
REPORT A TURNED OFF
REPORT B TURNED OFF
TOTALIZER RESET
INTERROGATED
SAMPLER ENABLED
SAMPLER DISABLED
ALARM ACKED BY #X
ALARM NOT ACKNOWLEDGED
YSI pH ADJUSTED
YSI D.O. ADJUSTED
YSI CONDUCTIVITY ADJUSTED
PRINT FLOW METER HISTORY
• YES • • NO •
PRINT FLOW METER HISTORY
• PRINT SINCE LAST • • PRINT ALL •
To Next Page
Loading...
