Chapter 5 MACHINE DISASSEMBLY
UNI-3 Service Manual 5-1
MACHINE DISASSEMBLY
5.1 DISASSEMBLY PROCEDURE FOR EACH TYPE
CAUTION: Make sure to unplug the power cord from the wall outlet before starting the disassembly work.
The procedure of this section is based on that of BENCH TYPE. For the CUSTOMER DISPLAY and
OPERATION DISPLAY of ELEVATED TYPE, refer to the section 5.2 ELEVATED TYPE.
5.1.1 CASE COVER
Remove the six screws (orange) and one
hex screw (8 mm, green).
To Next Page
Loading...
Need help?
General
