Chapter 3 Adjustment Mode
3.2.7 Adjusting Cutter Blade Position
Adjust the cutter blade position when cutter blades are replaced or the unit is disassembled.
Screw holes are elongated allowing vertical adjustment. Fix the cutter blade position with screws (4).
Adjust the cutter blade position in a manner described below.
•If the cutter bracket has a mark-off line, adjust the cutter blade to the mark-off line.
•If the cutter bracket has no mark-off line, set the gap between bottom end of the cutter blade and the cutter
bracket to 5 – 6 mm.
* Mount the cutter blade horizontally.
<Cutter blade has no mark-off line> <Cutter blade has a mark-off line>
Cutter blade
Mark-off
line
Cutter bracket
Cutter blade
5 - 6mm
Cutter bracket
3-50
To Next Page
Loading...