ISHIDA WM-NANO - WRAP Tab Added to PLU INITIAL DATA

Chapter 2 Functions for Each Mode
2.3.4 WRAP Tab Added to PLU INITIAL DATA
The WRAP tab (TRAY No / WRAP MODE / VOLUME) has been added to [PLU INITIAL DATA].
1. Touch [PLU INITIAL DATA] in the SETUP mode screen.
If [PLU INITIAL DATA] is not displayed, touch ▼ or ▲ button until it appears.
2. The [PLU INITIAL DATA] screen appears.
Touch the [WRAP] tab.
3. Configure [WRAP MODE], [TRAY No], and [VOLUME].
WRAP MODE Select from [1:WR+PR(initial value)]/[2:PRINT]/[3:WRAP].
TRAY No. Specify a value in a range from 0 to 9999. The initial value is 0.
VOLUME Select from [0:FLAT (initial value)]/[1:LOW]/[2:MIDDLE]/[3:HIGH].
2-18