ISHIDA WM-NANO - 3.2.10 Adjusting Discharge Pusher Standby Position

Chapter 3 Adjustment Mode
3.2.10 Adjusting Discharge Pusher Standby Position
Adjust the standby position of the discharge pusher as follows:
1） Check that the standby position of the discharge pusher (from the front of the discharge pusher to the
backside of the plate) is 261 - 264 mm.
2） If the standby position is not at 261 - 264 mm, adjust the position with screws (2) on the discharge
pusher arm at the right lateral.
3） After adjustment, activate the discharge pusher and check again the distance to the standby position.
Front of the
dischar
g
e
p
usher
Backside of
the
p
late
Distance to the standby position:
261 - 264 mm
Screw
Discharge pusher arm
3-53