Chapter 2 Functions for Each Mode
FILM TEMPERATURE CHECK: Configures if the temperature in the wrapper should be checked
before wrapping.
FILM SENSOR CHECK: Specifies if the film existence should be detected for film feeding.
DETECTION TIMEOUT: Specifies a time to determine that there is no film
detected.
MEASURED VALUE: Displays the actual time of film detection.
2.4.5 UNIT TEST Added to Menu
The [UNIT TEST] has been added to the ADJUST mode menu. You can use this function to operate the
units for test.
1. Touch [UNIT TEST] in the ADJUST mode screen.
If [UNIT TEST] is not displayed, touch ▼ or ▲ button until it appears.
2. Select a unit you want to operate and touch [EXECUTE].
If the unit is not displayed, touch ▼ or ▲ button until it appears.
2-30
To Next Page
Loading...
Need help?
General
