Chapter 2 Functions for Each Mode
● To configure film
① Touch the [ADJUST1] tab.
② Specify setup value(s).
FILM MATERIAL Touch < or > key to select a film material from:
1:PVC FILM 2:PS FILM1 3:PVC FILM2
* [1:PVC FILM] and [2:PS FILM1] have different setup temperatures of
the sealing heater, while they are the same in the wrapping operation.
* [3:PVC FILM2] has a different film conveying operation. Use this
setting if the film is hard to peel off from the roll.
FILM CENTERING ADJ. Adjusts the stop position of the film for feeding.
Forward: Moving to the right (film conveying direction)
Backward: Moving to the left
The input range is from -99 to 99. The initial value is 0.
FILM LENGTH ADJ. Adjusts the length of the film for feeding.
Forward: Longer
Backward: Shorter
The input range is from -99 to 99. The initial value is 0.
● To configure temperature check or film detection
① Touch the [ADJUST2] tab.
② Configure temperature check or film detection.
2-29
To Next Page
Loading...