ISHIDA WM-NANO - Wrapping Control Unit (2;2)

Chapter 4 Hardware (Electrical)
4.1.4 Wrapping Control Unit (2/2)
1
P-1004* Dip switch setting
2
P-1006＊-4
NOTE:
Be sure to set SW2 to
ON. If SW2 is set to
OFF, program cannot
be downloaded.
No.
Board Name /
Parts Name
Function
1
Wrapping control
board
（P-1004＊）
 It implements wrapping machine control.
 The board is connected to the main control board, performing
communication and storing programs to flash ROM.
NOTE: P-1004 board has restriction on its versions.
Use the board having the version of Product No. 111-8341-82
or higher.
(For boot program, J0671C or later)
2
Safety circuit control
board(P-1006*-4)
 It turns ON/OFF the coil of the electromagnetic contactor.
 M2: It drives the film conveying motor.
 M3: It drives the left/right squeezing motor.
 M4: It turns ON/OFF the fan for the fan heater.
4-4