Chapter 3 Adjustment Mode
3.2.2 Adjusting Lift Height
Adjust the lift height with 4 mm hexagonal nuts. Prepare two 4 mm hexagonal nuts
1） Remove the screws (2) on top side of the cover.
Another cover in the back of the cover comes
off.
2） Release the lock lever to remove the lift head.
3） Remove screws (2) to remove the upper cover.
4） Remove screws (2) on the lower side to remove
the cover.
5） Place 4 mm hexagonal nuts under each shaft on both sides to create a 4 mm gap.
Cover
Lock lever
Another cover
Lift head
Cover
Cover
4 mm hexagonal nut
Shaft
3-33
To Next Page
Loading...