Chapter 3 Adjustment Mode
6） Lower the lift to the lowest position resting on the hexagonal nut. (Conduct adjustment in this position.)
7） Loosen hexagonal bolts on both sides (2 on the left and 2 on the right) to adjust height.
8） Remove the hexagonal nuts (2) placed under the shaft and set the lift head.
9） Check that the gap between the bottom of the shaft and the frame is 1 – 3 mm seen from under the
machine body when the shaft is lowered in the lowest position.
Hexagonal bolts
The gap between the shaft
bottom and the frame is 1 – 3
mm.
3-34
To Next Page
Loading...