Chapter 5 Troubleshooting
ID NO.
TITLE ERROR CONTENTS SOLUTION
0449 DON’T PUT YOUR
HANDS INTO THE
MACHINE
The safety sensor at the out-feed
part was cut during the operation.
This appears when the safety
sensor is cut (by hands or products)
during the operation and stopped
the machine.
If an error occurs during film feed
and if the film has not been cut, add
1000 to the sub error.
After checking there is no products or
some objects inside, press [RETURN].
0459 MACHINE IS
RETURNING TO
STAND BY
POSITION
Wrapper units are returning to the
home position.
Wait until each unit returns to the
home position.
It is showing wrapper units are
returning to the home position.
After it returned to home position, this
error message will disappear
automatically.
0461 FILM OVER
ERROR
Film went too far to the left side.
During the film feeding, film was
detected by the sensor at the left
side of the machine.
<SUB ERROR>
0001: It detected excess film feed at
the front when operation
started.
0002: It detected excess film feed at
the rear when operation
started.
0003: It detected the film by the
sensor at the front side.
0004: it detected the film by the
sensor at the rear side.
After removing the film, press
[RETURN].
Remove the film then start operation.
<Check Point>
1. Excess film feed at the front [B9]
2. Excess film feed at the rear [B10]
3. Check the connection of XJ11 of
P-1004.
0470 THERE IS
PROBLEM ON
WRAPPING
CONTROLLER
The initialization of the wrapper is
not completed.
The initialization of E2ROM of the
wrapper is not completed.
* Check sum value of E2ROM
memory data is NG.
[OK]
Initialize the wrapper.
5-19
To Next Page
Loading...
Need help?
General
